







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Ameristar Driveway & Pavers: The Orange County Owner’s Guide
If you’re holding a cracked Ameristar paver or staring at a section of driveway that’s settled and pulling away from the edging, here’s the straight answer: we stock and install Ameristar-compatible pavers, replacement edging, joint sand, and base repair materials across Orange County, and a typical paver driveway repair or partial replacement runs $700 – $5,000 depending on square footage and base condition. That’s parts, labor, and haul-away, with a written price before we touch the site. Most Ameristar owners we hear from in Orange County discover the problem the same way: a paver shifted out of place after heavy rain, a corner crumbled when a delivery truck cut the radius too tight, or the sand between joints washed out and the whole field started creeping. You don’t usually lose an entire Ameristar driveway at once. You lose one edge, then a low spot, then every tire track becomes a reminder that water is doing its work underneath.
Which Ameristar Models This Applies To
Ameristar’s paver lines run across a few distinct product families, and the compatibility gotcha we tell every Orange County homeowner is this: a 60mm paver from Ameristar’s standard residential line does not interchange cleanly with an 80mm paver from their commercial series. Thickness and chamfer profile matter. If you pull a paver from the edge of your driveway and measure it, you’re looking for one of three common dimensions: 60mm (standard residential, travertine-style and tumbled lines), 80mm (driveway-rated units meant for vehicle traffic), and 30-40mm (overlay/coping units intended for non-traffic areas). The 80mm Ameristar units are what belong under cars and trucks. We’ve pulled 60mm units out of older Orange County driveways that were laid as a cost-saver, and after ten years of Toyota Sequoias and delivery Sprinter vans, they crack along the chamfer because the substrate flexes under load. On the OEM-versus-aftermarket question: Ameristar color batches shift slightly by production run, so matching a ten-year-old color from an aftermarket source is a gamble. We spec OEM Ameristar pavers when a match matters and the homeowner wants a uniform field. Where aftermarket makes sense is edging, joint sand, and geotextile fabric, where performance is a spec sheet decision, not a cosmetic match.
Styles & brands we work with







Signs Your Ameristar Driveway & Pavers Is Failing
- Water pooling in the same spot after every rain. That’s a low point in the substrate, not a paver problem. The pavers are conforming to what’s underneath. Orange County’s clay-heavy soil expands in winter rains and contracts in summer, and any base that wasn’t compacted in lifts will show a dip within three to five years.
- Edge pavers creeping outward toward the lawn or garden bed. The edge restraint has failed or was never installed. Without a solid border, paver fields spread under repeated vehicle load, and every passing car pushes the outside course further out of line.
- Chalky white residue blooming on the surface. That’s efflorescence, a mineral deposit rising from trapped moisture. It’s not structural, but it tells you the joint sand is saturated and that water isn’t moving laterally out of the base. In Orange County’s wet-dry cycle, it appears on the north-facing sections of driveways first, where shade keeps the pavers from drying.
- A single paver cracked in the middle, not at an edge. That’s point-load failure from a concentrated weight, like a jack stand or a trailer tongue, combined with a void underneath. The paver is the symptom. The void is the problem, and the repair means pulling the unit, filling the gap, and re-setting the stone.
- You can rock a paver back and forth with your foot or a pry bar. It’s unseated. Maybe a tree root, maybe base wash-out. A rocking paver will chip neighboring units at the edges and eventually turn a two-paver fix into a six-paver replacement.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s the pricing for Ameristar paver work in Orange County, with real numbers so you know what you’re walking into before you pick up the phone. A paver driveway installation on a clean, prepped site runs $7,000 – $18,000 depending on square footage, paver thickness, and whether we’re removing an existing surface first. Driveway replacement, meaning tear-out of the old base and reinstalling from scratch, runs $5,000 – $14,000. For partial repairs, paver patio installation runs $3,500 – $11,000, and driveway sealing (for paver surfaces using a quality sealant, not asphalt sealer) runs $250 – $700. Every estimate lists parts, materials, labor, and disposal in separate line items, and the price we write down before work starts is the price you pay at final invoice. That’s not a policy, that’s the Garrison Standard. Our work carries the 365-Day Done Right Promise in writing: if the paver field, edge restraint, or base fails within a year of completion, we come back and correct it at no charge.
DIY or Call Us?
For a single shifted paver or a hairline crack where the unit still sits solid, a patient homeowner can pull the unit, re-set it in a fresh bed of sand, and sweep joint sand back into the seams. We tell Orange County homeowners to make that call honestly: if you can move the stone without a saw and it’s one or two units, that’s a Saturday project. Where DIY goes wrong is the base. Once you’re digging out low spots, laying fresh aggregate, compacting in lifts, and re-setting a field so it doesn’t hump or dip, you need a plate compactor and a level transit, and you need to read the site’s drainage before you bury the problem again. An badly repaired base shows up as a new low spot within two winters and you’ve spent the time only to repeat the price. Same with failed edge restraint: the border is load-bearing and the fix has to tie into the existing field mechanically, not just visually. If you’re seeing settled sections, repeated efflorescence, or multiple cracked units, call us at (562) 262-2907 and we’ll walk the driveway with you, write the scope, and give you a number you can plan around.
FAQs

With a properly compacted base and correct 80mm traffic-rated units, an Ameristar paver driveway in Orange County should last 20 to 30 years for the pavers themselves, with the sand joints re-swept every two to three years and the base redone only once, if ever. The pavers rarely fail from age. What fails in Orange County is the base underneath, because our clay soil expands and contracts and any water that doesn’t drain out speeds that cycle. Call (562) 262-2907 if you’re seeing the warning signs now, and we’ll tell you if it’s a simple re-set or a base repair.
Yes, in most single-section failures, Ameristar pavers can be pulled, inspected, and re-laid without replacing the whole driveway. The exception is a base failure that has spread beyond a local low spot. We’ve repaired Orange County driveways with a twelve-paver patch that cost under $2,000 and driveways where a failing base required tearing out half the field. Our written estimate always splits out what gets repaired versus replaced so you see the line before we cut anything.
A contained paver repair, like replacing a cracked unit and re-setting its neighbors, is a single-day job. A full paver driveway replacement across an average two-car Orange County driveway takes three to five working days from tear-out and compaction through laying, cutting, and joint sand. Weather shifts it, and we don’t cut corners to shorten it.
We carry common Ameristar paver sizes and colors on hand for repair jobs, and we’ll special order anything outside our truck stock through our normal suppliers. For older Ameristar colors no longer in production we will tell you that up front and walk you through the closest matching options with samples in daylight, not from a catalog photo. Call (562) 262-2907 for a free estimate and a straight answer on your specific paver.
Written by Curtis Lane, Owner, Bradford Remodeling Co – Orange County at Bradford Remodeling Co Orange County, serving Orange County and nearby areas.


